Campsites

The campsite is your biggest invisible cost item

Hundreds of sites on one connection, each guest has a fixed surcharge, and only at the annual settlement do you know what it has become. We measure per site and settle per guest.

Measuring per siteSettling per guestMID certified
What goes wrong

Hundreds of places on one connection

The campsite is the biggest cost item you don't see, because it is not separately itemized on your bill.

Everyone pays the same

The caravan with air conditioning and two air fryers pays the same as the tent with a phone charger. The difference ends up on your bill.

Empty places that keep drawing

Four hundred watts at a place where no one is standing goes unnoticed. Over a hundred places, that's no longer a detail.

The sanitary building that no one checks

Boilers, hand dryers, and heating run all season long, and you notice a device that breaks down through complaints.

Start with the places

At most campsites, electricity is a fixed amount per night. The caravan with air conditioning pays the same as the tent with a phone charger, and you pay the difference.

Meters in the existing field cabinet make that visible. Prepaid or postpaid, set per place. And a place that is vacant can be turned off remotely.

Next come the sanitary building, the swimming pool, and the accommodations: water, heat, air quality, and the fill level of the waste containers.

Start with the places
What it delivers

What changes when you measure by place

On the bill AND at the reception, and the latter is usually underestimated.

On average, about 20% lower energy costs

Consumption becomes visible and guests pay for what they actually use. This changes behavior faster than a brochure.

No more rounds visiting the cabinets

Measurements come in without anyone needing to step onto the field, not even on the last day of the season.

No debate at checkout

What has been measured is recorded. The billing can be verified instead of being an estimate.

Phantom consumption that stops automatically

You can switch off an unoccupied place remotely, and you don't have to remember to do that every time.

What we do for campings

What you start with on a camping site

The places are the biggest expense, so that’s where it starts. You add the rest as it comes.

Energy Management

From the main connection to the last pitch, with control included: charging, switching off and adjusting from one system.

Metering camping pitches

A MID-certified kWh meter per pitch, which can also switch. The guest pays for what they use, and a vacant pitch is turned off.

Gas metering

Per sanitary building instead of per site, and per hour instead of per year. A boiler that runs continuously is immediately noticeable.

Water metering

Read every ten minutes, on the meter that is already there. Water that keeps running at night while no one is showering is almost always a leak.

Monitoring temperature

Sensors on boilers, cooling units, and in buildings that are vacant. You know it before the guest stands under a cold shower.

Legionella management

The pipe temperatures required by your management plan, logged every ten minutes in a self-filling logbook.

Smart access management

Private sanitary facilities with a code that runs with the booking, and chalets and storage rooms on the same system. The locks are connected to the same gateway as your meters, so there is no need for Wi-Fi in the area.

Frequently asked questions

Frequently Asked Questions about RecraPlan for Campgrounds

Below you will find the most frequently asked questions from campground owners.

Next step

Start with the locations

That's where the largest item is on a campsite, and the fastest payback time. The rest you add when it suits.

Without obligation, even if the answer is no.